That was me, and I don't need them anymore.

I do need stock e-revo/e-maxx electronics. PM me and I'll give you my situation.

Just got my spool in the mail from E-Revonut! In great condition, and thanks for giving me a good deal on it! Fast shipping too!

I need a plastic stampede chassis and braces and a brushed system to rebuild an old stampede so my stepdad can have something to drive.

I have an Rcm Emaxx Idler gear and a full set of front/rear grey bulkheads for maxx trucks. Received them wayy after i had sold my emaxx and have now use for them. No need for pics really, they are in like new condition- the Idler includes rubber sealed bearings.

Anybody have a bottom plastic shock end for a Losi 8? Broke one the other day and the LHS is out of them and the "kit" deal it comes with is a bunch of other parts I dont need and its $10.

I've got a pede chassis with braces, a 20t titan and a novak rooster esc I'd be happy to PIF. The RX plug on the rooster is cut off, has about a 2" lead on it. The battery wires are also cut short, about a 1" lead each. Motor wires are fine, and theswitch is still intact. Will need all connectors though.

I need some 3905 axle carriers.
I've got a set of 3906 CVD's if I get those 3905 axle carriers.

Need some new driveshafts ^_^

hello everyone, im looking for any clodbuster rims or stock e-maxx driveshafts or an e-maxx tranny(willing to pay shipping for all but cant buy im low on green) for an all custom crawler project im doing. thanks -Wes

Anyone have a dogbone, about 3 and 3/8 inch long?

I have 2 just a smidge over 3.5 inches long. I used to use them on my rusty. :yes:

I snaped one of mine on my rustler. What'd you want for em?

I'll PM you.

Sending you a PM....My B'in law is in need of some bulks. and at some point, that idler (if I can get him to upgrade from the Novak.....)

does anyone have a motor(s) that would work in an e-maxx??

See my add, I'll trade for 32P 3mm pinions and jato spurs.

http://www.rc-monster.com/forum/show...667#post284667

What tooth count pinions are you looking for? I have a few...

I'm looking for 9-15 tooth count pinions. I'll take any 32P spur that will fit a rusty slipper set up that is 56 or 58 teeth. :yes: (also looking for rusty diff gears too) (keep in mind these are needed for a 1/8 shaft)

I'm looking for 15+....

Need some bearings for the Axle Carriers for the 3905.

4 Axle Bearings 6 x 13 x 4mm (TRX #5180)

4 Axle Bearings 12 x 18 x 4mm (TRX #5120)

Have some misc. stuff for the maxx for the PIF.

I bought some pinions, but does anyone have a e-maxx body??

2.5 or 3.3?

its a new style e-maxx(3905) but any body will work...