Putting( well, if I buy it in the future) it in a SuperMaxx with 8s, 1950/10 and Mike's centerdiff if it becomes available soon.

I bought the controller for now.. Going to use with my 7xl in a 8ight-t until I can get my hands on one of their motor combos...

Mine's gonna be used in my speed record car project to start with, along with one of the Castle motors when they're released. But once that's done, I'll chuck it in a monster and use it properly!

I'm going to wait until the motor combos become available and continue running 4s in my 8ight so I don't need to buy a new charger and powersupply. The power of the 1512 1y compared to my Novak HV4.5 motor may determine a few things however. Hopefully castle will eventually produce a 1512 1.5D.

When I buy it (within next couple weeks from Mike) it will go in my CRT.5 on 4s, and will probably try it out in my Revo on 5s or maybe even 6s in the future. :yes:

When i can, I'll get three, maybe 4. I plan to use one in my G2R with 1515/2.5d (1700) 4-6s LIPO, one in my Gmaxxwith a 12XL and 6s LIPO, I plan to put one to the ultimate test, In my Twinforce with a center diff (this was Promods New era chassied twinforce) with a 2250/10t and 4-6s LIPO. If i get a E-revo(traxxas one) I will get the motor combo and run it on 4-6s, and just beat on it till it screams. :lol:

HB LSP Pro - 1515 2.5DF 6S2p 4200 Lipo / 7-8s2p A123
GREVO - MM Combo when available...

Holding out for the combo here, first it will go into a hyper7 6S then on to a revo conversion with a center diff when I can swing it.

Going into a Revo here as well.

9XL and 4S for now, but I'm waiting for the "Castle-ized" Neu motors next fall, and 6 S if my budget allows! :-)

Loa

It will be in my RC8 matched with a Neu 1512 1.5d. I ordered a second one to go in a truggy that I am going to build later this summer.

same with me, it's going in my revo for now with a 4s, if it works great i'll be putting one in my x1 cr and getting a couple neu's and 5s batts.

better start saving now

I justed smoked my mm(literaly) in my emaxx. So i will be running it with a 9xl and 14 3300's 16 if i can figure out a way to mount the 2 extra batts. the sony li-ion cells that were in the review forum look like a very good cost effective alternative to lipo's. running them in a 6s2p config. would me a real monster in a maxx. My only prob. is my 977 wont charge anything higher than 3s. So i think ill just run my nimh into the ground. or untill i want something a little more.

I am going to replace the mm that is in my 8t. I might sell the 8t and get the e-revo or a the new hyper buggy but it will go in the 8t now so I can atleast try it out.

in a maxx kb45 8xl, 6s2p, geared for 60, what's a good wheely bar:lol:

Just sent my MGM in to get the software update. If the MMM shows up before the MGM returns It will go in my Muggy on 6s with 1515 2.5D. Likely to get another and change my 4s buggy to 6s.