Success! I found a servo arm that will work! It works great... wish me luck guys! :whip:

Great bud. You put the wrong servo horn on and it will just strip out on you.

Should work fine, i use a 5645 for steering on my Nitro revo

You can buy the 5955TG for $90 from ebay.

Ebay link

that is a good price for one I got mine for $110 I either bought mine from Mike or Impakt...I dont remember which one

Well, just got back from the meet... alot of fun, I have to admit! :mdr: I brought along two packs (7s2p & 7s1pA123's) the 2p pack lasted about 25 mins on pavement, just takes alot of juice. Then I was waiting for it to charge for 40 mins while they ran some more, and broke some parts...

One guy had a t-maxx 3.3, one had a Revo 2.5... no problem completely obliterating them! hahaha, but the third guy, he had a Revo 3.3, with some good upgrades: a big block engine that was quite powerful, extended length rear arms, and some anti-roll bar kit. He wasn't too far behind me as far as acceleration goes, but the extended rear arms helped him alot. I had some wheelie, and flipping problems when drag racing them. When drag racing the t-maxx 3.3, I was halfway down the parking lot before he got out of bog-nation.

We also had some jumps out too, I jumped maybe 6 feet, which is more than enough for me personally... he was taking it at 20 feet!

aaaahh, good times.

BTW, NITRO SUCKS!!! :lol:

Oh, I forgot to mention that I blew the tranny on the third run. The large plastic gear right off the input gear in the Revo trans, no teeth left. :whistle:

The motor ran very nice and cool (geared 42mph), 130F after two hard runs. Keep in mind this is the 1512 motor spooling to 38K, impressive if you ask me.

I think I want to get a 1515 Neu though for sure, after about 30mph, I can't wheelie anymore; a 1515 should help that. :yes:

Sorry, no videos.