I changed to the stock rear arms to see how that goes! I talked to mip about my cvds and they said it might not have gottend hardened all the way. I am sending it back to them tommarrow to get replaced.

I am still on the stock center driveshafts and they look new still(it was the shafts to the wheels that I kept killing)

I am hoping that changing to the stock arms that the bulks will hold up! If it does I guess I will get some rpm rear arms

I have the same problem. Up to jump two meters long jump, and I destroyed the rear bulkhead 8x. RPM from my shoulders and otherwise on the REVO very careful care. This is the only issue that worries me very much.
I finished reinforced but I do not see a change for the better.
http://wgeronimo.rajce.idnes.cz/Lama...ULHEADU/#album


At a temperature of 5 degrees Celsius, I broke the whole chassis. But it was a very big leap.
http://wgeronimo.rajce.idnes.cz/Jak_...8102009559.jpg

My self and a few others have talked to FLM, they will make alu rear and front bulkheads for the 1/10 scale revo and the 1/16 scale revo. no date set yet tho.

RC Solution rollcage is the best solution available currently.