People are using sensoreless outrunners with great succes on crawlers so I would think that motor should work okay.

I plan to put some screen over the side holes, which is actually the air exit. The air is drawn thru the hollow rotor from slots in the rear endbell and is exhausted thru the large side slots that you can see the fan thru. I may have to remove the fins to fit the beasty!

As far as high pole count motors go, they usually start very well. I run a fair number of outrunners in crawler and dtd apps and they do fine. The rotor is not very long, so I am hoping the high pole count and large rotor diameter will make up for that. Active rotor cooling will not hurt either!

So where's the picture of the million motors in your drawer? Or was that just a joke? :oops::neutral:

Guess I'm just too stupid to notice anything... :yes:



:mdr:

No comment on the last part...

I will get a pic of the drawer, must be 40 motors in there...

Oh boy, I guess if linc says that, I should get backhanded. :lol:

I just figured there was no need for the obvious to be stated twice...

:rofl:

Can't deny the truth.. :rules:

:whistle:

Word

And thats no joke.....:gasp:

So where's that picture!? :mdr: