![]() |
Have u put the low detection on?
|
yuppers hold for 10 seconds and chirps ..
|
hmmm try to bind it again or send in the motor or esc to traxxas
|
Yeah I thought to send the whole thing in and then they can see what the problem is.. I just want it to work right!
|
Quote:
You will ALWAYS be tearing that thing apart, checking temps, lubing, breaking ect. ect. |
What voltage are the packs at when you take them off the truck, then how many MAH do they take back in?
|
20c rating packs and hyperion charger and a racers edge super 2000 charger balancing every time. They are at 8.4/4.2 after charging 4.2 individually Ill take voltage off the truck tomorrow!
|
Quote:
|
Man, you'll love brushless. Were you previously a nitro guy?
|
Sounds like the ESC is thermaling.
Throw in the 'Speed pinion' that was included in the truck (it is 23T vs the stock installed 28T pinion) and it will significantly help with the heat. Will also naturally slow the truck down so you might not need to run it in training mode. |
If running 2s you should be fine with the stock pinion. If you are running 2s in parallel and getting 7 minutes but if you run an individual pack and get 20 minutes you may want to check your parallel adapter. Try taking it out of training mode and see if that works.
|
Quote:
|
Quote:
|
Are you running stock tires?
|
The motor/esc do sound awefully hot, esp for the smaller rig. If the motor got much hotter than that it could have toasted it right from the get go. It will get hot, and will cause a heck of a drain on the batts. That doesn't explain the run time on 1 pack. This is a weird one.
|
| All times are GMT -4. The time now is 05:08 PM. |
Powered by vBulletin® Version 3.8.11
Copyright ©2000 - 2025, vBulletin Solutions Inc.