Hence
My last line
" if you do just keep running it back and forth and see if the bottom of the servo is getting warm or hot
and Don't stall it and set the end points. "

and all i know as a fact if I put a "hot charged" 2cell lipo @8.45v
the my 2.4Ghz Reciver's Output is @6.06v.

and the same lipo on my old TRX 3Ch 27Mhz Reciver's output is @ 5.81V

I have run pretty much every servo I have owned at 6.5v with a ccbec. Never went over that. Radio makes a good point by mentioning correctly setting your servo endpoints. And do not sit on the rc jeff, that would be disastrous!

James, why dont you and Radio go make a buttmud baby.