Huh?

He means the 9920 i think,funny though,motors don't run each other too well:005:

i wouldn't try it though,sounds like a short or something in the motor.

Well i sent the quark back :o( thinking it was the prob, i ran the 12020 with the 10xl, and all it does is stutter, put the 9920 back in, seems good again so far! same set up i started with before the lehner! ALL I CAN SAY IS 685.00 and back to start! I'm a little TICKED?!?!?!?!??!?!?!?!?! yeah a little! I'm sure the 12020 is gone, but i think that the quark may be ok....The motor was used, and the bearings seemed fine, but the back lash i found...it's f'n terrible..read above for the description for it!

OK, after doing a few runs, my old system runs like a dream as usual. There's the answer folks.

What's the answer?

running the 9920 with a 10xl...

Why would going to a 9920 from a 12020 or 125B be the answer? That's odd.

The answer is that his 1930 is the problem.

Yep, thats the whole reason. The motor was the problem which is why the Qaurk was getting so hot, but i don't think the Quark was fried, but i think 12020 may have been a bad esc. it never had mid range and it fried my ubec. so i put the 10xl in and the 9920, and everything is back to where i started! ARRRRGGGGGG! The whole idea was to have a better system, but now i just have the same as i was running.

The 1930 came from me. I had it on a 7020 on a flm maxx. I ran the motor about 6 packs before the esc smoked the capacitors but still worked. I could get 20 mins of consistant run time with it. It would over heat the esc if run hard.

Unfortunately i couldn't get two min out of it...It's all good, nop hard feelings...I would do it again though CHC, you are an all right guy!

I would do an edit, but this needs to be said by itself.
I was never mad at CHC, he is an outstanding gentleman and is word worthy, and trust worthy. It was the sitch that was frustrating. Just needed to clear that! I hope you guys understood that!

The only thing I can think of is. When I had it on the 80b quark and it fried it surged the motor and messed it up. I never ran it after that. I think it may be covered under warranty. I liked that motor to.

No problem neweuser. It is frustrating for both of us. I have no problems working with you.

Thanks CHC. Let me know what you find out. Thanks guys

looks like you're rubbing off on me, neweuser. i'm having to buy controllers until one works. i'm trying the 125b now! have you sent the 12020 back yet?