That't not too hot.

This is odd..


I am downloading the movie to check it out.

Hang on..

Try another channel on your receiver. Might be dead.. Happened to me too..

The receiver is ok , itry the receiver with onother esc and works ok...

Did you used an UBEC with the speedcontroller?

Just saw the movie.

no i use internal bec

I would personally use a seperate UBEC with it. have you got one you can test it with? the only option i can think of at this moment is that the BEC is dead.

But the servo steering works ok...
Rene' look the lipo volts...too low for me

NOt good!!!!

In effect the pack it seems swollen...

Thats very bad, i would contact flightpower, sounds like a bad cell to me.

nevertheless I had set up the cut-ff of the quark to 3.0 volts

???

how come it didn't cut off?

Are you sure you had it set to the correct battery type? If you have it set to NiMH the Quark still lets you set a lipo cut off voltage and you might think you have it set to Lipo.

I dont know, but controller broke+battery failure....
AAAAAARRRRRGHHHHH!!!!!!

I set cut-off 3 volts per cells...