RC-Monster Forums - Transmission Pro's/Con's..........(E-Revo)

Page 2 of 2

Show 40 post(s) from this thread on one page

RC-Monster Forums (https://www.rc-monster.com/forum/index.php)

- Revo (https://www.rc-monster.com/forum/forumdisplay.php?f=24)

- - Transmission Pro's/Con's..........(E-Revo) (https://www.rc-monster.com/forum/showthread.php?t=7941)

jnev	10.02.2007 12:16 AM

Quote:

Originally Posted by BrianG (Post 120847)

The only weak spot I've seen is the little pins that hold the gears to the shafts inside. But a little modding and the use of Jato pins instead fixed that and haven't had issues since.

I was trying to do this, but I realized that the drill bits I have are not hard enough to drill through it... Are there any hardened drill bits that you would recommend for drilling through the shaft(s)?

Finnster

10.02.2007 12:22 PM

If you need drill bits, you can order bits from Mc Master Carr, harbor frieght or someother if your LHS (local hardware :) )doesn't have a good selection.

MMC has a very good and detailed selection menu where it details the diff bits for the diff apps. They have fractional sizes, number ga sizes, metric, etc.

RCShocker

10.02.2007 06:15 PM

Quote:

Originally Posted by Finnster (Post 120944)

Darn Finnster, I was looking forward to your comparison of the transmission's :yes:

You are NOT running the E-Maxx tranny the second time around on your Revo, are you?

kenkamm

10.03.2007 01:05 PM

Wow. You guys must drive a lot harder than I do. I have a Neu 1515/2.5D in mine with the stock Revo tranny and I run it with 8S1P A123s, and it must be a ticking time bomb because I haven't broken anything yet. I do make sure the slipper is allowed to slip a little, well, otherwise it would spend too much time on it's lid anyway. :yes:

All times are GMT -4. The time now is 04:52 PM.

Page 2 of 2

Show 40 post(s) from this thread on one page