You should also get associated chassis protection tape for the bottom of your chassis it will keep your chassis from getting scratched it cost about $10.00. I use it on both of my cf trucks it works great.

Where you get that tape from hippie?

I bought mine from the lhs, but check with mike i'm pretty sure he can get it he might even have some just not listed on the store site.

I don't know where my lhs is. Even if I have one. I don't think it is quite so local. I get a lot of my stuff online.

Ask mike i'm pretty sure he can get it for you.

I have three that are fairly close. Unfortunetly they're good for spurs(somtimes) and pinions(sometimes). They don't stock much aftermarket QUALITY items. I was there today to buy some new diffs case's and housings for my T. They had the Robinson gears but that was it. I bought the stock plastic again. I dismanteled my truck rebuilt the diffs, reassembled, and went outside. I must have made it twenty feet before that plastic cup gave up the ghost leaving me with front wheel drive (again). I blew reverse donuts till I was outta gas. Dug a nice pit I have to admit, but I'm out a couple dollars and a chunk of time. I have to do it again.

Mike do you have diff houseings<--(spelling) in stock?

What do you keep breaking there tomato?

Tomato were in florida do you live ?. I live in largo fl which is near tampa.,

Diffs keep distorting or stripping. I'm on my 3 set(6 pcs) in my E and T maxx. I did get some maxximizer cups with the Robison gears from Mike. I was going to put them in some houses I got off ebay but the houses ended up to be a defect from the manufacturer. So I got rid of them :( They were only $55 for both so... atleast I'm not a $100 or more.

Busted the plastic drive shafts. ( I guess we all knew that was comming). So I just got some cvd's. Busted numerous screws in my alum bulk head... Toast now I guess. I have a set of these
http://cgi.ebay.com/ws/eBayISAPI.dll...MEWN%3AIT&rd=1
comming in soon. A new set of bulks from integy(blue) to go with that blue CF chassis. Full Integey suspention kit (silver) to go on the new chassis. Now I'm debating on a new set of houses to go with the maxximizer cups. Maybe I'll put them in the other diffs from ebay?. I don't know.....

I had a little bit of problem with the diff gears. Never had to much until the 7xl. I ran the aluminum diff cup with the fastlane bulkless. I have a pole head on at 20 mph or so and didn't hurt nothing. Did you shim the side spider gears. It makes them stronger. I going to step up to the 7.5 rears. I am tired of having problems with the stock setup. I want to put another big motor on truck to. I like power. :)

If it is available, I can most likely get it. I have blue diff cases in stock, as the silver cases have been back ordered for a bit, along with spider gears if you need them.

would you email me some info on the blue diff cases.

mynameisyournametoo at netzero dot com

Mike the chassis tape is made be associated.

Yes, I am familiar with the chassis tape. The cheaper solution is to buy clear sticker paper at an office supply store. :)

How thick is it i have never heard of that stuff ?. Is it tough ?.