yes but how do you address the actual metal axle end of the shaft so it hooks up to the output of the dif or tranny? (the yoke end)

ahhh yes got it.......

thanks guys I may be on the road sooner than I thought.......let me see if I can go heat up some Velinion parts...LOL

I'll video the smoke

i used the origanal yokes from the nitro shafts

mmmm burn plastic gonna love it, dunno if you had an axle apart yet, but the slines only line up well in like one spot, make sure you note that

yes sir modded a few center shafts but never a axle shaft...yes I notice when sliding shafts together sometime there so tite but keep turning and find the nice slide.....thanks for the heads up

ya that plastic slag burns too

yea dont touch it lol, or stick your tongue on it!

Well that went pretty smooth....looks pretty bullet proof too

Big Greg you made my day....i had thought of that but didnt research enough to see how easy it was to trnsfer the yoke

I had to take about 1 1/4" off the female end and about 1/2 " off the male end and then like you said dremel a little off the inside of the yokes to get it to slide deep enough on to the tranny output shaft but it worked like a dream

yep glad i helped out for a change usually the one needing it lol, yea about every jump i kept breaking fronts until i did this, i dont think it will be a problem now, i did shave a little off my chassis but my tranny is about 1/8" off to the side, again glad i helped get a vid up!

got my $11 Towerpro MG996r servo installed and steering rods and saver installed

all she needs now is the unslow parallel battery connector cable and the esc mounted

tic toc tic toc tic toc

Any updates?

This thing is way to cool!

thats what i always wondered, how come we never got any vid?

Yeah, might inspire me to build another blacked out revo:na::tongue:

I have way to many trucks (projects)....seems like i'm allways building, or modding and driving less.......I need to thin out the heard and finish some of this stuff...the hold up on this twin V project is the unslow adaptor and all the tires need to be taped and glued which i'm dredding and I havnt got a good set of 3's on hand but I have two nice ones on the way ..maybe it will inspire me to finish this puppy

If not, I may want to buy it:yes:

I cant wait to see some vid!

Nice build!
I love the R1 too dude!