But I think it'll be over worked at that rate.

I've been looking at the Neu motor site lately, and I don't see any 1/18th size motors. Just the 1100 series w/ 2.3mm shafts. I may have to go with a Wraith motor instead.

The 1100 series look good for 1/18 I thought. At 1.14" dia and 1.7oz they are a little fatter than a mamba/hacker b20.

I would go with the 1105 1.2" long for a 18t and probably a 1107 for the bigger minis.

Any idea if that would bolt straight up? I also am clueless on gearing. I think that those are a little too big, judging by the amp rating it wouldn't work with a quark 33a controller which is what I intended to use. And it looks as if I'll be going 2s Lipo. This is beginning to be quite a plunge into the bank account.

I have been talking with B-p-p about their setups, so I'll see what information I get. I'd love to order from mike, the only deal is I need this stuff asap.

i was looking through the lmt sight, and found a motor that might be great for this 1/18 application, has anyone seen the 1020? its small and about the size of the normal 18th size motors

here it is::018: :004:

Damn, that thing is small. looks perfect though! what the ratings? kv?

Yea, I think I suggested one earlier in the thread. They actually have numberous ones to choose from. 1010-1050 if I remember correctly.

looks so tiny but definatly powerful, i would choose that over any other.
i was looking at pictures of bl motors on google and when i clicked it didn'ts say anything of specs concerning the motor.

The only problem is with all these other motors out there I'm not willing to pay $120 for a Lehner. My lehner basic was great, but it was a lot bigger too! I think I'm going for an Aon/Quark

Anyone know what gearing to use on an rc18t w/ 2s Lipo on a 5400kv motor?

I got my Duratrax Mini-Quake SE, Mamba 6800, Spektrum DX3... it's awesome... All I have to do is paint the body and I"m done....