while we are talking about bec's,
are integy bec's any good?:032:

Got a x1-crt pro on the way is the following still a good setup for 13/51 gearing and dual Orion 4800's?

Mamba Maxx
Wanderer 9xl
Monster heat sink
ubec

opinions please.

Sounds perfect for racing and hard bashing... you should have room to gear up a little for speed runs.

Bummer the Wanderer 9xl is out of stock would the 10xl be good or should I just go with the fiago 9xl?

By the way this is deffiently going into a x1-crt with the hb front and rear 43/10 diffs and a 51t center gear powered by 2 Orion 4800 lipos controlled by the Mamaba Maxx.

Speaking of the diffs do I have to get a full diff assembly or can the HB gears work with the ofna diffs? These are new and it would be a shame to toss them aside.

Thanks

they should fit, all parts should.
i think.
cuz they've both copied kyosho.

Well, the 10xl will obviously be a little slower than the 9xl at the same voltage. If that's OK with you, or you can up the voltage a little to compensate, or don't mind gearing up a tad to compensate, then go with the 10xl.

How about the feigao 540 8xl is that getting too hot?

I assume you are going with 4s? The 8XL should be perfectly fine with that.

8xl should be fine. Have you contacted Mike to see if he may havea 9xl around maybe? But on 4s, an 8xl would be better anyway.