is this it serum??
http://www2.towerhobbies.com/cgi-bin...?&I=LXUR87&P=7

That's it.

got my MIP CVD shiny 2.5 today!!!
heres a pic of em
http://img.photobucket.com/albums/v4...mipcvdrear.jpg
they for the rear ones for now
ill get center and for the front ones soon hopefully

i deleted the earlier pic to make a smaller one here
http://img.photobucket.com/albums/v4...ipcvdrear2.jpg

wut to ask for for X-mas???
I know its along way till christmas
but i unno which to ask for...
G3 race suspension?
or g2 xbrace chassis?

Wow, well if you can actually get that much money out of somebody then go for the chassis.

but but but isnt the g3 race suspension more expensive??
ehh i need the chassis anyways mine right now is all messy cuz of the HV

Serum!
i got a Q
you see the pic i posted on page 3??
I was wondering wut the 2 black thin tube like thingy that came with the kit???
thnx

Aren't those pin's for your wheel adaptor?

nope the pins are silver not black and they are longer than those black ones

the black ones are for your wheel adapters the silver ones are for the joint in the cvd.

so it goes in the hole in the axle to put your hex on??

yes

uhh
i wanna get these...
Fat Boy Motor Mount Lunsford
will they fit the HV maxx??
cuz the ones that came with the HV are already stripped i have to use pliers jus to take it off
are these longer and will it damage the HV motor??
titanium is stronger right? and wont strip?

Just take a close look, if the screws are not too long, it might damage the motor permanent

I just use 10.9 M3 screws to tighten the motor to the plate. And be sure to use a proper key to tighten and loosen it.. Most of the time, those screws get stripped from using the wrong size or poor quality keys.

if i get deans plugs
which solder should i use??
deans racing solder w/ proflux?(do i still need to get flux by trinity?)
or get novak silver racing solder and trinity flux??

I use silver containing solder for those things..

deans are silver racing solder w/ proflux
does that mean i dont need to get flux no more??

Nope, you still need flux. Sure you could solder without flux, but then the connections would just fall apart. Seen it first hand.

so if i still need flux which would be better?
Novak silver racing solder or the deans one?

Personally, I just go to Rad Shack and get some with flux in it. This is super easy. (And it works well with my cold heat)

ok my center shafts finally snapped in half
i can still drive it only 2wd
should i wait till these shaft twist and earn money or shouled i get MIPs now??
right now i have 96$$$ saving for a spektrum DX3 radio