RC-Monster Forums - Nitro 4-Tec conversion

Page 3 of 3

Show 40 post(s) from this thread on one page

RC-Monster Forums (https://www.rc-monster.com/forum/index.php)

- Brushless (https://www.rc-monster.com/forum/forumdisplay.php?f=12)

- - Nitro 4-Tec conversion (https://www.rc-monster.com/forum/showthread.php?t=13358)

azjc	07.11.2008 02:14 AM

Quote:

Originally Posted by lincpimp (Post 189938)

Yeah, me too. I have the mount design in my head, and just need to free up some time to make it and test it. It is very simple, you will most likely laugh when you see it...

I would make the battery tray, but I always do that last, after I have everything else mounted, and sometimes I even wait till I have tested the setup. You may notice that some of my vehicle have cool ziptie battery mounts:party:

my Rustler has ziptie battery mounts also...you do what you gotta do.....

bl-is-future

07.11.2008 08:31 AM

between zip ties and duct tape you can fix the world. (at least for a little while)

Takedown

07.11.2008 10:18 AM

Looks to be another sweet conversion linc. Good luck!

lincpimp

07.11.2008 10:38 AM

Quote:

Originally Posted by Takedown (Post 190440)

Looks to be another sweet conversion linc. Good luck!

Thanks TD, I hope I have some time this weekend to fool with it...

lincpimp

07.12.2008 01:35 AM

Got all of the parts at hand now. I think my first plan is to assemble it and get the belts setup correclty, and check for any drivetrain drag. Than I can make the motor mount and install everything.

I am still debating if I should go with the clutch or not. I have a feeling I will give the clutch a try, if only to help the motor overcome the high gearing.

Going to try the 5700 on 2s first. Simplest wiring, and I have it all handy.

Fast5sRevo88

07.12.2008 01:20 PM

Just curious Pimplinc, does that Tekno motor mount attach into the adjustable engine mount slots? If so it would be great for any nitro conversion.

lincpimp

07.12.2008 03:13 PM

Quote:

Originally Posted by Fast5sRevo88 (Post 190777)

Just curious Pimplinc, does that Tekno motor mount attach into the adjustable engine mount slots? If so it would be great for any nitro conversion.

I does use m4 bolts, and the mount points are 32mm square. So it may fit some chassis...

brushlessboy16

07.14.2008 11:36 PM

parts car only 85 bux
http://www.rcuniverse.com/market/item.cfm?itemId=413192

All times are GMT -4. The time now is 08:58 PM.

Page 3 of 3

Show 40 post(s) from this thread on one page