Heya Ncabz.

The receiver is fed with the power from the esc you only have got two plugs in the receiver. (steering servo and esc) and perhaps a 3rd for the shifting servo

The man rushes you to get it and you forget something and wham. You a bad guy. Go figure. Yes I have mail out the other batts. Sorry dude I get it to you. Don't sweat it.

should i try to make a temporrry one or just wait? Ur not the bad guy! but still! i thought u lost it or somethign and i woulda been screewed.

Country doesn't know the term 'screw someone' ncabz..

No you wouldn't mike could sell you one. :D Mike can get almost anything. I think they 3 bucks.

nah! i made one! i had to hacke the plug from one of my escs and then solder another plug from my rx pack, but it works!! lol, don tworry, the esc was a fried piece of crap.

lol, its always nice to have some old escs lieing around that dont work, for spare parts that is:)

ALL MY PARTS ARE HERE!! now waht? DO i slide the tranny ONTOP of the revo or do i put it below? It wont go in, so will i have to expand it?

panic attack ncabz.. Don't you love 'm....

Did you took a close look at the pics of Daniels truck?

ya. He shaved it right? im trying to do it with a dremall... and one fo them shaving bits.. igot 2 millmeters so far.....

does the tranny fit at 2mm? If not keep going. Make sure you keep it even on both sides. don't want lop sided tranny on the truck.

omg!! i cant cut the chassis!! i spent 3 hours with a dremel, trying to shave away enough so the tranny can fit!! nada!! i dunno how am i gunna be able to make them custom batt trays and rollbar....

It isn't too hard to do. just dremel patiently until the tranny drops in.

a dull bit make it hard to cut to. Make sure you have a decent one.

nbcazn, i used one of those cut off wheels that brakes real easy. i used about 6 but it worked.