yeah heres the best one http://www.rc-monster.com/proddetail...MBO2200&cat=20 select motor only and mike will ship you one for 150. much better for a emaxx than a medusa as the endbells are closed. plus castle always makes good on the warranty

Good catch......Yea, I would prefer unbiased recommendations. Oh, wait I think that is an Oxymoron.

And if it ceased to amaze you, than I am taking Donations....

I have one that still amazes me but isn't being used if you are interested...

Arct1k....you have a pm ;)

i had great luck with a hv4.5 and the mmm , in a e-revo , i geared it to novaks rec. and the temps where fine.

check youtube for a vid of mine on the track , it ran great


it will work good for now , go for it , and later get a medusa , the 6.5 will get good run times as well


http://www.rc-monster.com/forum/showthread.php?t=15511

http://www.rc-monster.com/forum/showthread.php?t=15064

I see that you have the smaller shaft (1/8") HV, now you were running on 4S right??? Isnt the 4.5 5000kv???? If so, wouldnt that be like 74000rpm???? or was the old HV4.5 KV different???

yeah its a old 1/8 shaft motor , and novak says on their site its 5000 kv


yeah 4s


if geared according to novaks specs , it will run ok , i had no temp issues at all when geared with a 12t on the 4.5 motor , it was about 120f , and a 13 iirc jumped to 145f so i ran a 12t


also remember that a monster trucks trans has a gear reduction , not a great set-up but if you have the motor it will work fine

I had a novak hv 4.5, awsome motor for anything <1/8

escpesialy a slash:surprised: the motor is defintly over 5000kv, it was faster than my MM 5700 motor:yes: