lol..well that means I will just have to trade mine for the 2215 2y on OSE

hes in dire need for 1521/1Y:whistle:

He must not want one to bad, I pm'ed yesterday that I had 2 1521 1y for sale with no reply at all.

I talk to him twice he wants to trade but he is from australia and only has 4 posts at OSE
So I asked for some rating somewhere or he would have to ship first

Havntt heard from him since.....LOL

Australia, I'm out, thats got to be some killer shipping prices. haha

Yes it is. I did it one time, and never again....

well hes shipping me the 2215 sat morning
as far as shipping to australia

trading a $135 motor for a $450 plus a cooling can....I'll send to australia as many times as they want...

Got my motor today! It's nice having Neu about a 1.5 hour drive away.

http://img.photobucket.com/albums/v1...m/IMG_8398.jpg
http://img.photobucket.com/albums/v1...m/IMG_8401.jpg

There isn't really even a single scratch. The shaft has 2 flat spots, but that's the only thing wrong that I can tell. Also, the rear endbell is held on by 4 screws, and the front is held on by 1.

Is having 2 flat spots a problem? Why?

lol ya he aint going to break that 8mm shaft with 4 flat spots on it

I have a 8mm shaft 1527 that was in a jet edf and crashed at 150mph... Still runs true and does not have any issues. I doubt that you could ever damage that shaft easily...

That is one thick shaft you got there man.

I did break the shaft on my medusa, but that's only 5mm.

lol...

I picked up the bantam charger and a couple batts. 2 of my 5S zippies have lost a cell, and HC no longer has zippy-H's to even replace them with. Crappy cheap ass zippies!

in the end, I have only paid $20 more for ea of the Neu lipos I have then I paid for the Zips. Better balancing and C rating to boot! Yeah Neu

Doo540, I thought you weren't selling that 1521 1y anymore?

One flat spot looks a lot cleaner than 2 :lol: Though there's nothing wrong with it per se.

Instead of having the shaft turned down to 5mm (maybe I like it thick :wink: ) I'm gonna try to set up my XLB with a 9mm wide plastic spur gear, along with a pinion of matching width.

Fin
I wasn't going to sell it but I just picked up 3 more Neu's so....I know have more motors then trucks. Send me a pm and I will send you a full list of what motors I have.


Has anyone run a Neu Helicopter motor in there trucks yet? It has a built in fan and the wires come out of the front side of the can, 1515H 2.5D I might give it a ride in one of my LST2.