RC-Monster Forums - Hot deals on Neu 1521's, 1515's

Page 4 of 4

« First

Show 40 post(s) from this thread on one page

RC-Monster Forums (https://www.rc-monster.com/forum/index.php)

- General Discussion (https://www.rc-monster.com/forum/forumdisplay.php?f=20)

- - Hot deals on Neu 1521's, 1515's (https://www.rc-monster.com/forum/showthread.php?t=21512)

BL_RV0

06.12.2009 05:25 PM

Quote:

Originally Posted by MetalMan (Post 295149)

One flat spot looks a lot cleaner than 2 :lol: Though there's nothing wrong with it per se.

Instead of having the shaft turned down to 5mm (maybe I like it thick :wink: ) I'm gonna try to set up my XLB with a 9mm wide plastic spur gear, along with a pinion of matching width.

Pinion is gonna cover the other spot.

BP-Revo

06.13.2009 04:02 AM

I just received my 1112 in the mail today. Wow the shaft is hard to turn. This is going to be one torquey motor!

I can't wait to drop it in...too bad the damn mini E-Revo won't be here till Thursday or Friday.

Anyone know if you can trim the wires coming out of a Neu or no?

MetalMan

06.13.2009 04:12 AM

Strange that it's hard to turn, this 1521 is the easiest to turn of all the 4-pole/slotted motors I've handled. You won't be able to shorten the wires, they're part of the windings.

BP-Revo

06.13.2009 04:19 AM

Thanks for the heads up. What connectors should I use? I'm thinking 5.5mm from Mike will be colossal overkill...what about 4mm?

MetalMan

06.13.2009 04:23 AM

4mm will be plenty! I bet you could even get away with 3.5mm, if that's what the stock ESC uses.

BP-Revo

06.13.2009 04:33 AM

I doubt the 3.5mm would cut it. The motor is rated for 600w continuous (1200w peak) on Neu's website. I am going to be running 4S lipo, and at that voltage a peak burst is equal to nearly 100 amps..

All times are GMT -4. The time now is 02:08 PM.

Page 4 of 4

« First

Show 40 post(s) from this thread on one page