imma laugh, " man i hit the throttle pulled a wheelie, then it just flipped and colors were everywhere!"

I see you flipped around the tranny. I was thinking about doing it but didnt want crazy wheelies because the lipo would have to be placed in the rear.

there is still room for the battery in front, but the trans is now lower and further forward then before, servo came in today :yipi:

massive load of parts should be here on monday... if i mom doesnt flip *explative* i accedentally broke the card slot door on her digital camera and she wants me to return all my parts in order to pay her back for it.... ugh

Just say you cant and will not return it. Simple as that...

she ordered it for me..

just got a 9xl smooth can with a De-magged rotor... plan to pull the rotor out of the finned 8xl and put it in the 9xl :D

Good luck. I hope the windings arent f'ed up aswell which they shouldnt be because of the higher "c" rating capability. Anybody know what stock feigao windings can handle? Because i know that Neu windings can handle 200c which is pretty outstanding.

i hope not...

and i hope the rotors are a direct fit..

now begins one of the longest waits in the history of man... equal only to when i get my first hobby grade RC.... W00t Rusty xl-5 :yipi:

Shocks and 8xl came in today.. they are HUGE!

news flash....


just got the warhead together...
pretty sure i got screwed over on the 8xl ran good for the first few seconds.... then went south.


I set the truck on my floor, and fired it up-calibrated my MM, everything was good.
forgot reverse stength.... did a frontflip on my floor, WOOHOO


then shut it down, took it outside on our concrete patio.. started up just fine... went off throttle just enough to move then it locked... then noticed that the rotor had almost a full centimeter of play...


Pretty sure i got effed over in this dea. :no:

and now im out of money so this project is postponed untill further notice.

What about these........
http://www.hobbycity.com/hobbycity/s...hless_Inrunner

Others on the site as well...w/ testimonials...mostly airplane applications w/ few nuts putting them in T-maxx's and 1/8 conversions.

I wouldn't trust a $30 motor personally. I hardly even trust an $80 motor! (Feigaos)

they are equivalent to feigaos, just screwed endbells (a plus)

Really? That's surprising. They have to lack somewhere to get to almost 1/3 of the price though...

they only lack the brand name..