And here is the bracket that will connect the diff-assembly with the top chassie plate and the side plates.

http://rsb.se/gallery/files/1/5/3/dsc04056.jpg

New parts - again... Starts to get expensive :cry:
Every single piece seem to come with a bill attached to it?

http://rsb.se/gallery/files/1/5/3/dsc04072.jpg

VERY Impressive, Your craftsmanship is impecable. All parts are well thought out and BEEFY.

You are the envy of the entire forum and everyone is watching anxiously to see more.

Started to fit the pieces together and cut of excess material

Side plates:

http://rsb.se/gallery/files/1/5/3/dsc04053.jpg

Lipo trays:

http://rsb.se/gallery/files/1/5/3/dsc04050.jpg

Thanks Bondonutz!

Question, are you dead set on that gear ratio? Or how will you adjust gearing if you have to change pinion?

Shims - very simple and dead stable.

Here I started to drill holes for the assembly of the machine. I was considering to laminate the trays permanently to the sides, but the assembly/dis-assembly would be difficult, an I stall have not decided on the position..

http://rsb.se/gallery/files/1/5/3/dsc04074.jpg

Thats what I had in mind as well. Just seems to be time consuming...

Some more images with test assembly

(The gray dust in the corners of the trays are carbon fiber dust)

http://rsb.se/gallery/files/1/5/3/dsc04079.jpg

http://rsb.se/gallery/files/1/5/3/dsc04080.jpg

Extremely rigid setup :wink:

AWESOME build :D
Cant wait to see "THE flight of the tuned savage" :D :D :D:yipi:
Don't break it at the first bash !
Your "JUMP" will be recorded on several cameras under different directions ?

It will break so I hope to catch the jump on video at the first shot...

Some more parts (and $)

http://rsb.se/gallery/files/1/5/3/dsc04085.jpg

Gotta have LST2 shocks, right?

http://rsb.se/gallery/files/1/5/3/dsc04086.jpg

Lipo, straps and new HV Hitech Servo:

http://rsb.se/gallery/files/1/5/3/dsc04087.jpg

The small 2s Lipo is for the receiver and HV servo

Gotta have one of these HV servos is such a big truck:

http://rsb.se/gallery/files/1/5/3/dsc04096.jpg

Motor Type: Coreless
Bearing Type: Dual Ball Bearing
Speed: 0.12
Torque oz./in.: 403
Torque kg./cm.: 29.0

The assembled Shocks compared to the old 1/5 shocks i used before
(and yes, they are ugly, but gold was so cheap @ amain)

http://rsb.se/gallery/files/1/5/3/dsc04103.jpg