1 rustler rear red camber link + 2 revo gtr shock ends = matching revo steering linkage!

http://i2.photobucket.com/albums/y17.../steerlink.jpg

Nice!

Is that a camber link or a tie rod?

my error. rear camber link. I just grabbed it from a bucket.

about the center diff. your going to love it on the track but it jumps better with out it.

Looks very tight! Just my advice on the whole thing, I know money is an issue. But dont be afraid to splurge a little to get the results you want. No one ever said that RC was inexpensive and you went from Blah to WOW in a nice way.

I just ordered my 17t mod1 pinion an neu endbell dust cover from mike and my 1515 1y from a guy out in Oregon (sorry Mike, I tried to wait).

Team3six, I am splurging on this, that is why it is taking so long. I could have gone the 8xl MM route and had it running already, I have spare MM laying around. here's hoping taht next moth when I get round 2 of 2008 budget from wife Mike has an mgm 16018 in stock!

Did the tranny work today.

Stock:
http://i2.photobucket.com/albums/y17...nny_inside.jpg

Wide ratio:
http://i2.photobucket.com/albums/y17...wide_ratio.jpg

Center diff:
http://i2.photobucket.com/albums/y17...enter_diff.jpg

2nd gear locked, I'm trying it with the centrifugal clutch locked in rather than against the pin. If it hold's, great! if not I'l get another disk and redo it. I clamped it in a vice and connected an 18v drill to the shaft. no flex at all.
http://i2.photobucket.com/albums/y17...r_halfmoon.jpg
http://i2.photobucket.com/albums/y17...ear_locked.jpg

Finished, 1st gear removed:
http://i2.photobucket.com/albums/y17...y_finished.jpg

My Neu 1515 1y/s came today!

front, I have a cover on the way.
http://i2.photobucket.com/albums/y17...0day/front.jpg

rear, no dust cover
http://i2.photobucket.com/albums/y17...y/no_cover.jpg

rear with dust cover
http://i2.photobucket.com/albums/y17...dust_cover.jpg

Neu Revo!
http://i2.photobucket.com/albums/y17...day/e-revo.jpg

looks great

It lives!!!
 

Still missing lipos and an MMM, but it runs! 12 very old and tired nimh and a MM with no ubec. GriffinRu has my MM right now performing his stage 1 mod. lipos get ordered next Friday.

pardon the messy wires, this is just a mockup, they will get cleaned up.

temps after 12 mins were batts 114, motor 109, esc 111

http://www.youtube.com/watch?v=0h4aQhrz_wg

http://i2.photobucket.com/albums/y17...-08/mockup.jpg

http://i2.photobucket.com/albums/y17...08/action1.jpg

http://i2.photobucket.com/albums/y17...08/action2.jpg

What are your initial thoughts on the center diff your running? I'm mostly wondering if seems to unload excessively?

It was fine on these batteries, but it felt like it was at the end of it's holding abilities. When I have some good cells pushing it I will need thicker fluid. I have 300k in there now. will get 500k and id that doesn't do it, try ofna diff lock lube.

What is the stage 1 mod?