I deemed the likelihood of having the bolts for the shocks lasting a full race to be 0% - I just had to make a reinforcement

http://rsb.se/gallery/files/1/5/3/dsc04128.jpg

Front view - quite massive?

http://rsb.se/gallery/files/1/5/3/dsc04135.jpg

The pieces held in place to see how it looks..

http://rsb.se/gallery/files/1/5/3/dsc04144.jpg

And a front view

http://rsb.se/gallery/files/1/5/3/dsc04142.jpg

Total weight RTR ? :yipi::yipi:

Apx 15 pounds = 7.3kgs including all bolts, cales, clips, body etc. I did put it on the scale before the test-run..

cales = cables if not in a hurry when writing..

Don't forget to equilibrate your wheels, it's very important for the speed you want to reach. I suppose that the tires are tapped ?

Hi Nuz

I don't really understand what you mean.. Perhaps it is my English - could you elaborate a little?

Balance the wheels and tires for less vibrations and smooth running.

Taping the tires is a form of belting, like a steel belted radial car tires. It helps resist ballooning at high speed.

Yes sorry, equilibrate = balance dor me ^^

Ok, thanks. I was not aware of belting before. It sound like a very good idea. Thanks again.

So, servo in place in a simple & stable way.

http://rsb.se/gallery/files/1/5/3/dsc04162.jpg

In this compartment I plan to fit the receiver Lipo as well.

This is were it should be placed, but it cannot be in contact with the side shassie as there will be the nuts for the lipo tray sticking out.

http://rsb.se/gallery/files/1/5/3/dsc04169.jpg