Send Lightning Chassis pics to me as well, please!

firgures!!!

You get first shot at it, I am not trying to buy it out from under you, but if you don't buy it for whatever reason, I want second shot at it.

right on, but i havent seen any pics yet??? maybe he is just talking?

Maybe we need to leave him our email addresses? I just thought about that, heh...I never gave an email address for him to send pics to, lol!

that could help!!! but he has never asked for it, or replied yet. if he wants it? are you going to leave them racer x arms we are bidding on alone?? i wont bid on the vbs's if you do?

Yea, I don't need the RacerX, but I REALLY, REALLY need the VBS.

retract your bid then?? might be to late.

I have already been outbid on the RacerX, but I have been speaking with him, so I will see what I can do..

ya, by me

Cool deal, you won them...rock on!!! If I can find it in my insanely messed up RC Room, I have a Racer-X Rear Lower H-Arm in pretty good condition, and I will send it to you if you want it...I don't need it since I always run Setbacks on all my Racer-X Suspensions.

ya, i run the setbacks also, i plan to sell the rear lower arms, and all the front arms, all i needed was the knuckles, and one rear upper arm. i still would like to find a set of 16mm ones though. being i have a set of 8mm cvds. thank you for the offer of the one arm though.

If i do decide to sell the UE chassis, i have to give a fellow in Netherlands first crack at it, as I promised him that a few years ago. I will post pictures here if you want - the truck is almost rtr, but only the chassis and a few other components on this truck in particular are UE. I have a 2.5 T-maxx with the smallblock Dace chassis, UE single speed and racer X shocks and suspension on it as well somewhere - used to be a kick-ass race truck back in the day. I plan on keeping the racer x, vbs setup on my old race G-Maxx, though(I hope to someday bring it back to show/race condition and keep it for posterity, as it has an original emaxx part on it somewhere(before widemaxx and before Novak ESC). The truck was really what got me started in business, though it changes many times through the years, Emaxx parts and hopups and brushless setups were my core business for the 1st couple years in business.

You can run the 8mm CVDs in the 15mm knuckles with the use of 8x15x5 bearings. They are a little bit difficult to find, but they are out there...and you can run them until you find a set of 16mm knuckles. Or, some people have successfully milled the knuckles to 16mm, so if you have a local machine shop, you could go that route. Maybe Mike might do it for you, as I am sure he can do it right.

That's cool...and how glad we all are that you did decide to get into the business of what you are doing, heh!

SO, the VBS-T is not for sale?

But please post pics, I would like to see everything!!!