Nice CHC!! I cant wait till i get my e-maxx built!!:)

I thought it fit(music). blew out one tire and broke both body mounts with a battery strap. It was not a bad day. :D Mounted my new tire last night. I may go out with 18 cells and try it again.

Some people wanted to know what a 9xl would do on 12 cells. I got a short clip of some action today. Nothing like a monday off to play with RC. :D
http://www.rcpics.net/img/67096

Cool. I like that. How long will it run on 12 cells

http://www.rcpics.net/img/67100
I didn't upload the whole video. Here is a little bit longer one. It shows more of the truck. I did not time my self crazy. I geared the truck with a 16 51 ue rears and a single gmaxx tranny. It should be as close to stock gearing if figures was right. I got about 17-18 minutes on a pack but the cells sat for a while. It only took about 2400mah on charge. I can get back to you on the run time if you like.

is that a nova in the back ground?

The white with a green lightening bolt on the side. Yes it is. It is my brother in laws drag car. No motor. been a 7.20 in the 1/8 mile.

whats it run in the 1/4?

Just got a timed run on a 9xl with gp 3300. The batteries charged up to 2934 in one and 3052 in the other. Run time is 15 mins. It is probably under close to race conditions. I tried to keep truck going at a good rate. Donuts and power slides. I hope this helps.

Okay! I got my new motor for it. I going to a 7xl feigao. My new crime fighter tires are in as well. I ordered up a center diff for it to. I will have to get back to you on speed. I want a video of the 7xl.

Okay! change of plans. I have took the aluminum tranny off. I have mounted a center diff in it. I have to wait on a couple parts to see how it is going to go.

Its looking very good, whenever i look at your truck its taken apart:p Where did you get that center diff?

I got the diff off ebay. I made the rest over the last couple of days. I am hoping the my motor comes in and mike gets my other parts shipped out. I am curious to how it is going to do. I have not drove nothing with a center diff. I will find out when finished. thanks for the kind words.

Cool have you seen the new one peice extinion from UE ?.

http://www.unlimitedengineering.com/...=14319&acon=39

It's a 1 lb solid billet of 7075-T6 Aluminum that's machined down to weigh a mere 68 grams.
Full stress analysis and optimization was done to ensure that it is up to our high standards of strength and durability.

This will fit any Maxx style chassis which has the stock mounting holes.