Heh, I've seen a couple Hvmaxx escs that smoked after being ran- they were left with the batteries connected, and something inside smoked, melting the case and pcb....

That's Novak though... :lol:

Ouch dude.. that hurts.... Any videos of the truck running when the damage happened?

Reason to get mmm :oops: Welcome to the line hehe.

No, I haven't got video....... I send my controller to mgm with the motor, wait and see. Thanks you

hello, some news, my controller is definitely dead, the outputs from motor (I mean the wires which come from motor) has "pushed out" its isolation. The vibrations caused that and wires that come from motor to controller touched on motor frame (motor skeleton). two of motor outputs touched in same time, this caused short-circuit between phases and this damage the controller. So I have to buy a new controller, witch controller will be the best, MMM or mgm 224-18 or an other ?

Thanks you

MMM, all the way. With the revised BEC design I see no reason why it wouldnt be the best choice for a ~200amp 6s lipo esc.

http://img84.imageshack.us/img84/9333/spa0045je2.th.jpg
http://img512.imageshack.us/img512/2...0047jv6.th.jpg
http://img512.imageshack.us/img512/2...0049uy5.th.jpg

some news with my controller from rc monster

Looks very nice!

thanks you, according to you, can I keep the internal bec? with my 6S lipo, I have only 2 servo...

Yes. You can use your internal BEC, providing your 22418 is the new version, shown here:
http://www.rc-monster.com/proddetail...22418CP&cat=21

okay great :), thanks you

No problem. :smile:

Nice truck sucks about the controller. I think I am going to get that controller as well. Should run everything I want.... at the same time.

I hope too.......