ok, i have downgraded to 1.24 software. i hope this works. is the 2200kv motor supposed to spin in steps? :neutral:

Yes, there are 12 distinct "steps" where the rotor likes to sit, per revolution - most notable when you try to spin the rotor by hand. Is this what you are refering to?

Yes, there is sort of a lurch then go to it (I call it a sort of chop or detent). It is due to the design of the motor, it's similar to brushed. the wires are wound on iron cores but in the can instead of the armature shaft. I have a Neu 1515/2.5d, similar to your but wound different, and that is normal

Tried to race with 1.28 tonight and it was a no go. I will wait the two weeks for the new firmware. Does look very interesting though.

yes, this is what my motor is doing. so i just wanted to make sure it was fine. also is the motor supposed to be hard to turn by hand?

It will be due to the powerful magnets and motor design.

ok cool. thanks guy for all the help. i just dont want to be a pain in the ass.:mdr:

I've been off flying airplanes/helis for the past year so I've been out of it for a while, but I've got 3 MMM. Are you guys looking for anymore feedback on this beta release? or are the comments pretty much in? I had put my 1/8 buggy conversion away a year ago because the MMM and feigao 10L combo kept breaking the hardended steel shafts and the gears in the diffs. This feature sounds like what I have been looking for.

if your killing diffs with a 10l i think you have another problem..:whistle:

Need a better buggy... But this torque control should help smooth out the power on acceleration.

RD Logics SHO buggy. Maybe I do need another buggy. But this will definetly help. The 10L broke in half one of these.
http://cgi.ebay.com/RD-LOGICS-SHO-CV...item3a4a79be04
Not at the joint, but snapped it at the center of the shaft. I know the gears in the diff were stripped too at a certain point.
I'm with you guys on the 10L, but it lights up all 4 tires. I was thinking about the Castle 2200 for a while, but that would have just been overkill.

No offense, but I've never been impressed with RD Logics quality. I associated them Integy and the like...

No offense taken and I appreciate the truth. I thought it was a bit odd a 10L taking out a CVD like that especially when my Castle 2200 puts out way more torque on my 3905 emaxx and I havent broken anything yet. I'm pretty sure the steel gears in the diffs were taken out too and thats just crazy. I think I'm going to try the torque control and see if I can keep it together. If not, I'm going to strip it down and sell it off as parts.

Hey Patrick...I just wanted to say... Thanks a million!!!... I got my ESC today :yipi:.. I love the service you and your company provides for the RC community...

Thanks again
Alien

Success!!! :yipi:... everything checked out with the new ESC... I will use 1.24 until the new beta firmware is resolved.

Alien