![]() |
Nue Motor Failure
Well my racing hopes for tomorrow are out - The rotor failed on my 1515 2.5DF - It slid forward 6mm or so... :(
Off to Neu on Monday hopefully for a New one... PS did a nice 48mph jump with the CRT .5 - 3 rotations and perfect landing sadly video didn't work the first time... Lesson learned do not try stunts like that twice! Second time I landed on the wing... So far it looks like it just ripped the rear diff case to shreds and mangled the rear centre driveshaft - Anyone know the part number for the latter on an extended ofna chassis? Video of the latter jump hopefully coming... |
hmmm crazy, was it the hard landing? that is what it sounds like
|
Not that I'm away of it was put away fine after I last used it. I got it out today and put a pack in - I was just pulling away from stationary on tarmac - Nothing special at all... Mystery to me...
|
|
If you need a ext ofna chassis I have one.
Sorry to hear about the motor |
I sent a motor back to neu with a loose shaft. It left my shop on thursady, and I got it back on monday.... No charge and very fast turn around.
|
hmmm mystery to me to, i beat the snot out of both mine at the races today, both ran great!
|
I just need the length of the rear centre shaft - I see the kit comes with a 60mm one I just can't remember if you swap the old (short kit) front to the rear and the 60mm goes in the front.
or is it the old (short chassis) rear goes in the front and the new 60mm goes in the rear! Anyone have the extended chassis instructions? |
Its ext'd in the F. The rear is the same. I know as I bend my first rear bone.
Wow.. sounds like I missed a heck of a jump :) |
I worked it out
Stock Front 44mm Extended Front 60mm Rear 82.5mm |
Quote:
|
Quote:
I sent mine in last week, 2 weeks for repairs now. They are quite busy. Even so, 2 weeks ain't half bad! |
Quote:
|
Quote:
|
no he's got a 50mm medusa in the .5. The Neu is in the hyper ST
:D |
I may have read the first post wrong, but it looked like he was talking about the CRT.5 and the neu as in the same setup
|
Quote:
|
| All times are GMT -4. The time now is 07:35 PM. |
Powered by vBulletin® Version 3.8.11
Copyright ©2000 - 2025, vBulletin Solutions Inc.