E-maxx tranny for revo conversiON?
 

How much does a used one ussually cost? Its market value on ebay? I gunna get a hv-maxx, with 14 cells, would i need steel idlers?

COME ON!! auction is endign soon! dunno, what price to bid! 1/2 hour!

40-45 max.

Damn...
Item # 6009398463....Its really overpriced.

you didn't say it was a chassis servos and stuff
I got a question for you aznmaster.
You planning on running the g2r chassis.
Well you need a two speed tranny? Can you even run a servo to switch gears? With that in consideration. Will you need the single gmaxx conversion?

Wait, is it?? with all the extra stuff on it! i cant find any e-maxx trannies aat ALL!!

IS IT WORHT IT YES SSS OR NO!!! 5 minutes!!!

IS IT WORHT IT YES SSS OR NO!!! 5 minutes!!! HOW MUCH SHOULD I BID!!!!

SCREW IT! 80 bux is too much

i just peiced one together from new parts for a friend. i bought most of the parts at RCBoyz but had to get a couple of things from Tower. all together it cost me about $80-90 for a brand new tranny that i got to put together. oh and that included the upgrade lightweight input and output shafts. no spur setup though

beats the $100 on ebay they usually get and the $130 i think it is on Tower

did you even read what i post. it sold for 77.01
not 80

I hope your friend don't put brushless on them lightweight shafts. I had them and rung the two ends of the output shaft and took the teeth off the input shaft. mike will sell you one for 95 with steel idlers.

Ya, but theres no bearings. No, motor mount, now slipper setup! Ps, cool, get on aim!

well against brushless the stock slipper is useless anyway. and i think it would include bearings. not sure though.

I have heard of them going for $60 on Ebay, used. Just keep looking, you are bound to find one.

I've seen them go for $100, used. Multiple times.

well i saw one go for 40 a few weeks ago. to bad nbcabana