Brushless Heatsink
 

Hello,

Is the Brushless Heatsink compatible with the BK Electronics Wanderer "XL" Brushless Motor ?

Thanks

Hello Ptitoine! welcome to this forum!

yes, that heatsink is compatible, just choose the L/XL version.

thanks Serum

You are welcome! if you have got any other question, feel free to ask!

I should have a blue annodized "xl" heatsink in the next week or so as well! FYI!
Welcome to the forums, ptitoine!

ok ;) thanks mike

I look for a BL setup or my LST
BK 6XL + BK Warrior 12020 + HeatSink should be ok

will you have the motor soon ?

Thanks

Hi, welcome on board! :D

How many cells do you have in mind for thes 6XL? 12 NiMH or 4S Lipo I would guess.

Mike should get the Wanderers pretty soon. Somewhen this week. In another thread he said in the next few days.

12 to 14 cells, no much lipo at all, they are too dangerous

a picture of my M18 with lipo (http://ptitoine.free.fr/CIMG0627.JPG)

I would run the 7xl. for 14 cells.

What lipo's where that ptit?

I go with country! get a 7XL instead. you could also get a 9920 instead of the 12020,

yikes! thats not good. looks like something damaged them.

-corey

it's a kokam 2s 1500mah. it explode when I charge it (same program as usual)

Something must have been wrong there. Definitely. Sorry for your bad luck.

It's a good idea to take the batt out of the car for charging. And to keep a bucket of sand ready, just in case :eek:

Yes, I agree with the others. The 6XL would be too hot on 14 cells. Get a 7xl. You can also save some bucks and get the 99amp Warrior.

You don't use a balancer do you?

can you explain a little bit what's a balancer ?

thanks

A balancer is just what it says. If you run a 3s pack of lipos. A balancer will make sure that the three cells are the same voltage.

for charging; you can ballance the cells, so they get both charged at/till the same voltage.

What if your packs have no balancer plug?

You can add them.. it is possible you might need some special solder.. (depending on the material of the tabs)

Okay. Will the balancing wires have to be thick, 12g wire?

I guess my Lipo charger won't support ballancing anyway.

No, a balancer is a seperate device, that needs a lipo charger.

http://www.thunderpower-batteries.co.../chargers.html

check that 205 or 210.

Lordamerci, another thing I need:rolleyes: Will this never stop? LOL

Thanks for the input, though.