my STE is done
 

Just wanted to throw a pic up of my ste. I have been using this forum a lot for info on what and how for this RC. I just have the diffs to do and install my new 2.4 Futaba when it gets here next week.
http://i125.photobucket.com/albums/p...fna/ste003.jpg
http://i125.photobucket.com/albums/p...fna/ste002.jpg
http://i125.photobucket.com/albums/p...fna/ste004.jpg

Sweet, looks very nice. Also loving the MMP in there :).

thanks me too.
I am happy i did not get the EZRun i was originally looking at.

very nice....done any testing w/it yet? Is the motor one of castle's new ones?

Oooh, I like how that looks, like it alot. :yes:

Time to do some reading up me thinks...

In looking at your truck further...it seems that a 1"stretched chassis would be ideal, especially w/those tires.

yes it is the new MM Pro. I have about 2 passes in it. It was dark that night and has been wet since...

From what i have seen so far, on 2s lipo it is going to run very well.
I may try a 3s just so i can say i did LOL

Neil, i like it. It is set up like a 1/8th scale uggy including the braces.
I do not plan on racing it, just bashing it some.

Cool, thats what I wanted/ needed to hear; my main concern is the diffs holding up to bashing, since the rest of it looks very tough and well built- not skinny or flimsy at all. :smile:

if they are the same as the crt.5 then it will be fine.:yes:

nice car
are the wheel the stock ones ?

HPI rims and HPI Geolander tires

Great Looking ride !

Great looking car, my compliments !!

nice truck, i loved my crt.5 conversion


the diffs hold up to alot, you will be suprised

Nice car!

I also like the body; nice and a simple design! :)

thanks gang. I am impressed by all the comments and compliments here..

We're one big happy loved-up family.

Q. Where the heck can one actually by the ste though- only places I've found are Tower, Stormerhobbies and Nitrohouse... :neutral:

mine came off RCTech. Seller bought new and never did any thing with it.

I see them on ebay for the $160 Towers and Nitro house wants..

luven that wheel and tire setup , how o you like it so far ? can u send em a link of exactly what to purchase ? Id liek to try it out also , oh and are there any clearence issues with those wheels and tires or is it a simple drop in

direct bolt on set up. I PM'd you back.
thanks

I have an issue with the servO
Can you make a picture of the right side of your ste ?
Thanks

http://i125.photobucket.com/albums/p...fna/ste005.jpg

hope this helps..

Yes thanks

In fact, I have taken down the servo from my emaxx and left the servo saver on it. I need to remove it.

i had tried to use a Kimbrough saver also and it is too thick for the lid.

I bought Dubro standard length servo arms from my lhs for around $8. They worked fine. You would just need Futaba splined arms.

i have same problem, my servo arm is too thick.

Does that MMPro fit below the stock body ?

so here's what sucks, i sold this... person i sold it too did not use it.. now i am buying it back as a roller and am planning on throwing my SCT3800 in it... what sucks is i do not remember what gearing i was at LOL... Hoping 15T is a good start.. Looking forward to getting this back.