9L and stock Emaxx motor mount
 

Is it just me or do I need a new motor mount?

20/72 with the Feigao 9L and 5mm 20 pinion. There is no way to get these to mesh with the stock motor mount right?

I have no idea what I was looking at earlier. It fits with ease. I think I might be going crazy or something.

"I have no idea what I was looking at earlier. It fits with ease. I think I might be going crazy or something."


It happens to the best of us! Of course, I am not ruling out the crazy idea! :)

ok it's official. I am going mad. The 20/72 doesn't fit (again), I'm going to have to Dremel it out a bit. Either that or I'll just run a tame 16/66 for a while.

16/66 will bump up the torque and lower top end. Not sure I would call more torque "tame"!