RC-Monster Forums

RC-Monster Forums (https://www.rc-monster.com/forum/index.php)

- General Questions (https://www.rc-monster.com/forum/forumdisplay.php?f=7)

- - Hv 110 (https://www.rc-monster.com/forum/showthread.php?t=13684)

azjc	07.20.2008 06:24 PM

Hv 110

I have a HV 110 that I am going to use in my Revo and it doesnt have a BEC but it states that its OPTO if I use a BEC would I need to remove the red wire like I would if it had an internal BEC?

lincpimp

07.20.2008 07:11 PM

No. If I remember correctly you may have to leave it in so that the esc will work.

What's_nitro?

07.20.2008 09:48 PM

True opto-isolated controllers have the power boards completely isolated from the "brain" boards. You would keep the red wire in place to provide power to the brain board via the BEC.

azjc	07.20.2008 09:58 PM

Quote:

Originally Posted by What's_nitro? (Post 193311)

True opto-isolated controllers have the power boards completely isolated from the "brain" boards. You would keep the red wire in place to provide power to the brain board via the BEC.

so in that case the BEC would supply power to the Rx and the RX to the brain board?

83gt	07.20.2008 10:03 PM

Quote:

Originally Posted by azjc (Post 193314)

so in that case the BEC would supply power to the Rx and the RX to the brain board?

Correct :).

J.

azjc	07.20.2008 10:11 PM

Quote:

Originally Posted by 83gt (Post 193316)

Correct :).

J.

thanx for the reply and I guess it was a good thing I looked into it I was about to pull the red wire.....I would have been pissed off ......:cry:

All times are GMT -4. The time now is 02:02 PM.