help pls.stupid mistake?
 

ive been running my v1MMM for a few months on my truggies flawlessly.i got some new parts for my emaxx today and decided to try on my MMM/neu on it.got everything mounted then when i tested it there was no power,after a few tries,got power to the servo but the MMM was blinking yellow.i panicked and wired everything back to the truggy.i have the servo working but nothing on the motor.it still beeps the first set of tones then flashes red/yellow continiously.WTF?!any ideas?ill call castle tom but im still trying right now so suggestions could help.thanks

Are you getting tones on the motor - It might be just out of range with the rx - Have you tried re-calibrating?

it still does the first set of tones.servos work fine so its in synch with rx.cant recalibrate it for some reason

the first say its armed, the second say it's synched, try to recalibrate. This is the way on the MM, If not on the MMM, sorry

i finally got it to work!:party:i tried a different rx.bad news is i think it took out two of my rx's(i hope it didnt)ill check again later.i cant explain how it did it,it worked perfectly right before i mounted it on my emaxx.

lesson learned:IF YOU HAVE A WORKING MMM SYSTEM,DONT MESS WITH IT,LEAVE IT AS IS:lol::lol::lol:

as usual,thanks to you guys that tried to help.appreciate it