need a couple MMM measurements....
 

well i forgot to get these while i had one here i need to go ahead and make my mount but i need these two dimension that are labeled x, y, and z in the pictures below, thanks alot for the help guys.

X=33mm, Y=33mm, and Z=10mm. Hope that helps. :wink:

thanks , im guessing its a 30mm diameter hole for the fan?

Well, the fan is 30mm and the outer fan housing is 33mm total, and a 1.5mm wall thickness sounds about right. So without opening my case, it's probably just slightly more than 30mm (to allow 30mm fans to fit snugly) internally.