Finnaly! My E-revo Is Really, Really Complete!!!!
 

My e-revo is done, I polished all the alminum till i can see myself, and mounted everythgni on, heres some pics=. HOpefully the snow will clear up so i can drive it.

another one

and another... OH yeah, i installed fans on it and eveyrhting, teh biggger one doesnt blow as fast as teh small one. So i think they balence eachother out, it wouldnt look nice with a big fann on a small esc, and a small fan on a big motor

Gimme ur thoughts and opinions. I know it isnt as nice as dafini's.....

Very nice, much better like this than cardboard:)

oh shoot! i forgot to get a screw taping kit so i could put the skidplate, i still gotta chop up the revo engine moutns too! lol, watveer! i'll do it l8ter. I"ll just put some 3M tape between sikd and tranny

lose the receiver pack and get a ubec. other than that it is nice. I like hippies battery holders. Could use some velcro straps on them to.

ya i know, dunno if i can install g-maxx strasp

Yeah, that is an option Ncabz..

You could get some normal velcro too though.

Do you have anything holding the batteries down vertically? If you don't, the batteries could *jump* and fly out, and possibly break.

im pretty sure that they have a aluminum tab bent down on the top.

Look closely at the middle of the tray at the top. I put a piece of 1 inch wide black kydex plastic with foam to hold the battery's in verticly. I used kydex plastic so the tab wont short out the battery's Jackson your EVO looks good.

thx to u! also, i geared it up, and im kinda sad that on a 19/70t, that it couldnt wheeelie :(

didnt i tell you that was to high of gearing?!?

lol, teh esc never got hot consideirng it was 30 degrees outside, and i had fans on both of them. Probbably was the batts.