RC-Monster Forums - hyperion EOS0606i

RC-Monster Forums (https://www.rc-monster.com/forum/index.php)

- Brushless (https://www.rc-monster.com/forum/forumdisplay.php?f=12)

- - hyperion EOS0606i (https://www.rc-monster.com/forum/showthread.php?t=18187)

hyperion EOS0606i

Hi everyone, has anyone had any experience with the hyperion EOS0606i charger? Is there a way to set the desired voltage per cell and still have it charge to full capacity? I am using a 3s 5000mah 15c lipo pack. Right now, it charges to it's max capacity (4.2v/cell), and I would like it to be at 3.3v/cell, but still charge to full capaicty. Does anyone know how? Thanks!

Err no full capacity is 4.2v

Read this http://www.rctoys.com/pr/2006/12/05/...mer-batteries/

No their is not. I was also looking for this feature but flipped threw my 6i's programs and the manual and found nothing.

Quote:

Originally Posted by emaxx 101 (Post 254088)

...Is there a way to set the desired voltage per cell and still have it charge to full capacity? I am using a 3s 5000mah 15c lipo pack. Right now, it charges to it's max capacity (4.2v/cell), and I would like it to be at 3.3v/cell, but still charge to full capaicty. Does anyone know how? Thanks!

About the full capacity question: Like Arct1k said, nope. :smile:

Anything lower than 4.2v will reduce the capacity. You can get away with lowering the CC/CV threshold to around 4.0v/cell and not lose too much, but you will still lose something. I have my Xtrema set to 4.15v/cell just as a little safety margin in case a pack is not fully balanced before the threshold, and haven't noticed any runtime loss. But I don't exactly time it either.