Help me before I go nuts!!!!!
 

I programmed my new mamba micro tonight....this is my 3rd. mm controller so I am not a newbie w/ these...calibrated ok, or so i thought. Anyway, now I have 80% reverse when I programmed only 40%...I have maybe have 50% throttle when my end point is set for 120% and 10% is programmed into the controller. I checked and rechecked my settings to no avail. Now it will not recalibrate...go figure.

All I get when I try to recalibrate is a constant blinking red light until I let off of the throttle and then it will work but not calibrate.

I figured it out....I repeated the steps I had been doing and then PRESTO it worked..go figure...:neutral: