Anyone doing any mods to the new e-maxx trans?
 

I am looking at one for my REVO conversion,....yes, Revo, and was wondering if anyone has modded one. I want to make it bullettproof as I can

The new trannys seem to be holding up well. As much as I'm on here I haven't seen anyone complaining about blowing one. I would like to see a half case like the G-Maxx single speed cover for the original. It is a pretty big transmission and most of it is unneeded.

I dont think there are any mods, just throw a little grease in there to quiet down the gears... Only thing that would make them stronger is throw them in this case.. LINK to Ebay

Stronger as non-flexing

ive seen a few break the cases but never any gears or shafts

Can anyone tell me if the mounting sides sit correct on the gorilla maxx chassis's, If so, i could drill and tap that. (I know Linc will get some fun out of that)

I laughed at your comment...linc will have a field day w/it if he sees this!:yes:

I prefer pounding it in place myself... But whatever works best for ya!

he has a certain attraction to phrases, that could be considered as gutter talk

true, true....always in good fun!:mdr:

Anywayyyyy...

No, wont fit the old Gmaxx chassis as the tranny is narrower, and mounting points are closer together- hence the mounting adaptor sold by FLM briefly...