Integy bearings and UE 8mm cvds
 

Do the bearings supplied with the UE 8mm cvds fit in the integy knuckles? I'm wondering b/c on the rcmonster site it says that the integ knucks use 15 mm bearings, while UE's knuckles use 16mm. thanks

You won't be able to find any 'fair' priced 15 mm bearing with 8 mm holes. (at least, I couldn't) you see, it is not a standard size, so they are not produced in mass, unlike the 16x6/ 16x8 bearings..

Sorry for that.. I looked for them as well for quite some time, but the only ones that you can find are too expensive or not wide enough.

darn, thats what i get for getting integy...again

you got their 'racer X' copy?

I got the integy knuckles from mike. They have the 8mm bearing in them now. The older integy are different. I hope this helps you.

I had the bulkheads, you can figure out the rest of the story. The bulks bent where they meet the chassis.

Coolhand, i'm not quite sure what your saying, but I to bought these from mike. So do you run 8mm cvds?

I have a set of 8mm and 6 mm ue cvds. Both are run on integy knuckles.

The 8mm cvds are run inside Integy pro3 knuckles, which have a 16mm bearing.