need some advise
 

ok im tired of looking at my costum truck that i made sitting in my room just bagging me to drive it. so ive got a plan, i have 2 q?

1 do you think the average bec in a brushed esc could handle 3 standerd servos?

2 whats the fully charged voltage on a nimh 6 cell pack?

the second q? is cause ive got a old timer charger i wont to use, and i think if i check the voltage with a digital volt meter and stop it before or right at the full voltage of the pack i should be fine. right?

Not sure about the bec question but if you use a voltmeter and the charger is ok for NIMH's you will be ok. watch and when the voltage starts to dropand the pack warms up it is ready a full charged

The BEC could be heavily stressed, and could fry. The end voltage for a pack can't be figured out, as it depends on the internal resistance of the cells (which is much more complex to figure out than the end voltage).

hum ok guys tnx for the help