Mamba screw size
 

I have the 2200kv MMM combo.. what size are the screws that go into the motor holding it onto a motor mount??

Thanks in advance

I believe 3x10mm

They're 3mm diameter, how long depends on the width of your mount. After screwing in screws that were too long and trashing a ~$260 Neu (costing $105 to fix) I am VERY careful about my measurements. IIRC I use a 3x8mm cap head with one of Mike's mounts, you can go about 5mm into the motor before hitting the coils but the CC motors have a kevlar cover over the coils to help prevent this.

are M3x10 too long for an RCM mount and CC 220kv?