Almost new Castle HV-110 ESC controller
 

This controller is a spare I have that I no longer need. Great for the guys wanting to do brushless setups and run High voltage and manual brakes, or for RC Airplanes or Heli's. Specs are below...



This is the Castle Creations Phoenix HV-110

High Voltage, Brushless, Sensorless Electronic Speed Control.



FEATURES: Handles up to 36 NiMH/NiCd, cells or 12S LiPo (50V) maximum, 16 cells

NiMH/NiCd or 3S LiPo minimum

Up to 110A continuous current

Forward and reverse

Auto Shut Down when signal is lost or radio interference occurs

Smooth reverse exponential throttle

Audible Arming Signal

Self-calibrating endpoints: maximizes usable stick travel

Over temp motor cut-off with reset

User programmable options include:

Low-voltage cutoff with Auto-LiPo detect as default

Over-Current Protection

Brake Type

Throttle Range

Timing Advance

Cutoff Type

Soft Start ramp up prevents damage to gearboxes

Switching Frequency



INCLUDES: One Phoenix HV-110 Electronic Speed Control with 10AWG motor and

battery leads, Universal receiver connector and set up manual



REQUIRES: Receiver battery pack, Dual Opto-Coupled (no BEC)

Motor and battery connectors of modeler's choice



SPECS: BEC: None (dual opto-coupled)

Maximum Cells: 36 NiMH/NiCd, or 12S LiPo (50V)

Continuous Current: 110A

Minimum Cells: 12 NiMH/NiCd, or 4S LiPo

Switching Rate Programmable: 13, 26, or 52kHz

Resistance: .001 Ohm

Brake: Programmable

Reversible: Yes, change any two wires

Low Voltage Cut-Off: Programmable

Size: 1.55"" x 2.8"" x 1.25"" (39mm x 71mm x 32mm)

Weight (with wires): 5.3oz (150g)

Receiver Connector: Universal

jxs 9/01/05

ir/jxs



This is the same controller I used to set the monster truck speed record. This was the spare I bought. Also the controller was only turned on to verify it was operational when new, but not ran or mounted in a moving RC.



http://www.youtube.com/watch?v=ERY9_TLF86M



PM me for pricing.....