Tekno 2.5q
 

I have a tekno 1515 2.5 square can motor should i put something over the holes in the can or leave open.

What holes are you talking about? The Tekno can's are sealed up.

No, you do not need to cover them.

Cory- he is talking about the holes in the top of the can.

These holes:

http://www.impaktrc.com/images/TKR1515-Q.jpg

Nah, they bottom out in the aluminum. No worrys.

Put some screws in them, I would, if you ever would want to use them, then they wouldn't be full of dirt and debry.

What im talking about is where the wire comes out you can see right inside the motor.

Oh no, don't bother, not enough dirt comes in there to warrant any kind of sealing measure. My Neu is 2 years old now, and all I run on is gravel/dirt dusty conditions and it is very clean inside the motor. I only have the RCM Neu endbell cover.

If you want you can put some fuel tubing around the wires and between the hole. This will completely seal it up, but it's not a necessity.