New Jammin buggy?
 

http://www.neobuggy.net/modules/news...words=hong+nor

Looks like an interesting setup.

It looks like a very clean layout . I dont know if i like the lipo's being stood up on there side , it may have a effect on handiling . But that might be offset by the lipo's being so close to the center of the car . I wonder what the cost will be ?. I'm a little partial to the single pack setup's .

As far as weight balancing I figure run a 5s setup. Two identical packs wired in series, just one 3s and one 2s, the 2s on the motor side. By the calculator a NUE 1850kv with a 17 tooth pinion would be just about perfect for this buggy.

wow, that is one narrow buggy

thats odd. this is the Ex2 they were showing at the Toys Fair

http://rcspecial.com/news/wp-content...ur05021022.jpg
http://rcspecial.com/news/wp-content...ur05021021.jpg
http://rcspecial.com/news/wp-content...ur05021020.jpg

I saw that conversion kit on eBay in the special-rc store, $100.00 I think. I like the pics from neobuggy better. Was that at the Ofna/Jammin booth or Hong Nor booth?

jammin/ofna thought they were all the same company? (hong nor/ jammin / ofna)

Ofna's the distributor in the U.S. for Hong Nor and Hobao. What's confusing is if that's the Ofna booth then why is that not the Tekno kit, that's what they have been advertising the X2e to be sold with.

I want to like Ofna, but man, I think they change their minds faster than Xray.

I hv the jammin conversion kit problem is it can only take up to 16pinion. I switch back to Rc monster motor mount. I need 17pinion.