Medusa Bearing Replacements
 

I've got some really good service from my 36-70-2000kv.

Recently being ran in an E Revo geared 14/52 on 6S. Incredible Power!

It was pulled out to try another setup, when I noticed it didn't feel right while spinning it by hand.

After running it at low rpm, it's clear that it has a bad bearing.

The bearings are 5x13x4mm in size.

How well would these work as replacements?

http://www3.towerhobbies.com/cgi-bin...?&I=LXFKK6&P=7

Any suggestions would be appreciated.

You could always send it to Neu for replacement bearings. In answer to your question. I personally believe that better bearings make a difference. I replaced a set of diff bearings w/cheap ones and they did not last.

These would be better. :smile:

http://www3.towerhobbies.com/cgi-bin...&I=LXPVB5&P=SM

if u email neu u can get just the bearings from them and install them yourself, the are pretty cheap. i inquired on this for another motor i had sometime back