Product Review: COW R/C Screw Catcher Magnetic R/C Work Mats
 

Are you tired of having your workbench look like this???

http://i168.photobucket.com/albums/u...prMat_0002.jpg

You are working on your rig and your arm bumps the screw holder and all the screws fall to the floor.
You can't find your tools.
You are disassembling your rig and drop a drive pin and it bounces off the bench onto the floor.

Well not anymore...

http://i168.photobucket.com/albums/u...prMat_0003.jpg

Over all size of the Super Mat is 30"x 24" with a work surface of 20"x 18.5". That is excluding the hardware holders.

You ask what is so great about this mat...well here you go...

It transforms from a foam mat to a magnetic safety net for your parts and screws...

http://i168.photobucket.com/albums/u...prMat_0024.jpg

http://i168.photobucket.com/albums/u...prMat_0013.jpg

The mat offers you two large compartments for driveshafts, axles or tools.

http://i168.photobucket.com/albums/u...prMat_0020.jpg

http://i168.photobucket.com/albums/u...prMat_0019.jpg

And 6 small compartments for screws, washers, small tools, etc.

http://i168.photobucket.com/albums/u...prMat_0018.jpg

It is the perfect way to keep your workspace organized and eliminates that sick feeling when you move something and a dozen of screws, nuts, washers and e-Clips fall to the floor.

http://i168.photobucket.com/albums/u...prMat_0023.jpg

It gives you all the room you need to work on your scaler, comp rig...and even your Super...

http://i168.photobucket.com/albums/u...prMat_0021.jpg

http://i168.photobucket.com/albums/u...prMat_0022.jpg

They come in Three sizes:

Micro (9'x12")
Mini (12"x18")
Super (30"x24")

If you want to have a great surface to work on your rigs...check these out...

I saw them at motorama in person - they do look great.

Ps sweet rigs

Too bad they didn't get run...

I have to do something with the steering like yours...