can anyone verify if this lipo will fit a 3905 emaxx
 

i think the 3905 battery compartment dimensions are 160x45x20.
these lipos are 147x49x18. so its the height im worried about.
its off by 4mm. im just hoping theres a member on here that have these exact batterys or can tell me good news....i have heard that hobbyking's dimensions are off.

Which pack is it? Link maybe?

oops my bad
http://hobbyking.com/hobbyking/store..._40C_Lipo_Pack

Hey Dingle Berry, what pack ?

just measured one of mine: 19x49x143 (length not including wires)

darn. so the height measurement was correct then. while the width and length was off by a some mm's. geez. doesnt look like there are any zippy/turnigys out there that will fit a emaxx other than measly 20c packs.

get some hyperions from mike!

This pack will fit perfectly. Get 2 pairs.
http://hobbyking.com/hobbyking/store...dProduct=11614

These turnigy packs are pretty sweet. I have the 30c version in my flux and they barely get warm.

great find! thanks a whole bunch. i didnt see these packs because i jumped to page 11 because the previous pages were lower mah packs.
but they do have some higher mah packs in the earlier pages.

but just a little too late, i ended up buying some neu energy 25c 5k hardcase lipos from rschoi__75 (member here on rcm) last night.

but still good to know, ill most likely be buying these turnigy packs sooner or later.

edit:after reading some reviews, someone stated that these packs are actually 47mm hieght. and the emaxx compartment is 45mm in height.
are you using these only in your flux, or do you have a emaxx as well?

i've seen these packs fit into an e-maxx with no issues. they also fit nicely in the e-revo as well. they have similar dimensions as a standard 6 cell ni-mh pack, only they are just a hair taller. the only issues with size i have heard of is in those tiny on-road 1/10 and 1/12 cars that are limited to 23mm height.

ok got it. thanks for the help