guys..need some help w/the LB10A ballancer and what is needed
 

Ok..I have a hyperion 1210i and am going to upgrade my equinox balancer to the LB10A balancer. So, what do I need to get w/it... I am a bit confused as there are so many leads adapters you can get.

I am using JST/Align taps

any help would be greatly appreciated

The LBA10 leads plug into the output of the charger. The the LBA10 had leads that you solder your Deans, TRX, EC5... plug on to. Next to these leads is a balance port where you plug in one of these:
http://www.rc-monster.com/proddetail...LB10XHB&cat=19

Then you should be good to go.

You also need a male to male servo lead so that you can see cell voltages on charger. All 610i balance leads work

Thanks!:yipi: